NF KP3000GS, Instruction Manual

Page: 229 / 279

8. Troubleshooting
PROGRAMMABLE AC/DC POWER SOURCE 210
Table 8-2 Error Message List (Continued)
ID Message Protection
type
Cause or Necessary action
32 Calibration Data Error ME Message
display only
The adjustment data is abnormal. Cycle the
power. If it still occurs, contact the seller
(NF Corporation or our agent) from whom
you purchased the product.
33 Line Overvoltage System
Lock The power input voltage is excessive. Check
if the power input is appropriate.
34 Line Undervoltage System
Lock The power input voltage is insufficient.
Check if the power input is appropriate.
36 Communication Failure
PU
System
Lock There is a communication error between the
firmware and the power unit. Cycle the
power. If it still occurs, contact the seller
(NF Corporation or our agent) from whom
you purchased the product.
37 Communication Failure
ME
System
Lock There is a communication error between the
firmware and the output measurement
section. Cycle the power. If it still occurs,
contact the seller (NF Corporation or our
agent) from whom you purchased the
product.
43 Mismatched Pw Unit
Versions System
Lock All power unit versions do not match.
44 Unsupported Pw Unit
Version System
Lock A power unit of unsupported version is
connected.
47 No Available Power Unit System
Lock There is no power unit that can be started.
48 Output Overvoltage Output Off The output voltage is excessive. This may
occur at an abrupt change in the output
current due to the inductive load.