NF KP3000GS, Instruction Manual

Page: 261 / 279

10. Specifications
PROGRAMMABLE AC/DC POWER SOURCE 242
10.22.3 External Signal Input (only EXT and ADD)
This multiplies the input signal by the specified gain and outputs it. For ADD, the internal signal
source is added.
EXT: Output voltage (V) = External signal input (V)

Gain (V/V)
ADD: Output voltage (V) = External signal input (V)

Gain (V/V)
+ Internal signal source setting (V)
KP3000GS Factory default
Setting Range for gain 100 V range: 0.0 to 220.0 times 100
200 V range: 0.0 to 440.0 times 200
Setting resolution 0.1
Gain accuracy *36 
5 %
(DC, 45 Hz to 65 Hz, the gain is the factory default, the rated output
voltage, no load)
Input-output phase In-phase
Input terminal BNC connector (rear panel, unbalanced)
Also used as the external synchronization signal input
Input impedance
1 M

Input voltage range 
2.2 V (A/D resolution 10 bit)
Nondestructive
maximum input voltage

10 V
Input frequency range DC to 550 Hz (sine wave)
DC to 100 Hz (other than sine wave)
*36: DC or 45 Hz to 65 Hz, the gain is the factory default, the rated output voltage, no load.
10.23 General Function
Description Factory default
LCD display
setting Contrast 0 to 99
Color Blue tone or white tone White tone
Beep (key operation,
erroneous operation) On or Off
Alarms on abnormal situation regardless of the
setting
On
Key lock On or Off
On: Only key lock-off and output-off are available
Off
Output relay control Enable: The output relay is used to turn the output
on/off
Disable: The output relay is not used. High
impedance to turn the output off
Enable
Output setting at power-on On or Off
On: Output on after power-on
Off
Trigger output setting
Polarity: positive or negative
Pulse width: 0.1 ms to 10 ms (resolution 0.1 ms)
Negative
10 ms
Time unit setting for
Sequence and Simulation
ms or s s
Reset function Resets the items stored in the System Setting Memory (excluding the
external interface setting) and the items that are to be reset at power-on,
to the factory default settings.