NF KP3000GS, Instruction Manual

Page: 26 / 279

2.2 About Installation Environment
KP3000GS 7
 Install the product on a sturdy place.
 The floor needs to have enough strength to support the weight of this product. The mass of this
product is shown in Table 2-3.
Table 2-3 Mass
Mass
KP3000GS 50 kg approx.
 Do not install this product on a sloped surface. The Adjuster Foot is only for temporary fixing,
and cannot support the unit's own weight. You also must not lean on this product or use it as a
support. How to use the Adjuster Foot is shown in Figure 2–1.
Up Down
Adjuster Foot
Figure 2-1 How to Use the Adjuster Foot
 About arrangement
 Do not place the product on its side, back or top.
 Do not stack the product on top of the other, or place it in front or back of the other
(arrangement which makes the cabinet placed behind inhale the exhaust heat of the other).
 Other installation location conditions
 Use the product indoors, at altitude up to 2000 m.
 Use the product where the temperature is 0 to +50 degrees Celsius, and the humidity is 5 to
85 %RH (the absolute humidity should be 1 to 25 g/m
3
, without condensation). However, on
some specifications, the temperature range limit is stricter.
 Do not install the product in the following places:

Place exposed to inflammable gas

This may pose a risk of explosion. Never install and use the product in such a place.
The Adjuster Foot can be moved
up by turning it to left
(counterclockwise) as viewed from
above, and moved down by turning
it to right (clockwise). Move the
Adjuster Foot down by using a
spanner (19mm diameter).