NF KP3000GS, Instruction Manual

Page: 65 / 279

3. Basic Operation
PROGRAMMABLE AC/DC POWER SOURCE 46
 Operation procedures by using shortcuts
1. + Switching the display format of the measured values
Press the SHIFT key to enter the shift state (the SHIFT LED illuminates). When you press the 3
key of the numeric keypad during the shift state, the measuring mode is switched in the
following order: RMS, AVG, Peak, RMS. Some measuring modes may be skipped and cannot
be selected depending on the AC/DC mode.
3.4.10 Enlarge Display Letters for the Measured Value
You can switch the measured value display mode between normal (normal) and the mode in which the
letters are enlarged (simple) shown in Figure 3–14. In the Simple View mode, three types of measured
values are displayed. You can select the measured value being displayed in the Simple View mode.
Figure 3-13 The Normal View (left) and the Simple View Mode (right)
-------- Notes ------------------------------------------------------------------------------------------------------------
 If the measured value display mode is changed to Peak in the Simple View mode, the
maximum peak values (Vmax/Imax) are displayed instead of the voltage/current measured
value. Also, if the measured value display mode is changed to RMS/AVG from Peak, the
effective/average values are displayed instead of the maximum and minimum peak values.
 If the AC/DC mode and the signal source are changed in the Simple View mode, the measured
voltage values are forced to be displayed instead of the items that are not displayed in the mode after
the change, such as the power factor or crest factor. If this operation is applied to multiple items, the
measured current value is displayed for the second item, and the current peak-hold value for the third.
-----------------------------------------------------------------------------------------------------------------------------