NF KP3000GS, Instruction Manual

Page: 46 / 279

3.2 Power On/Off
KP3000GS 27
3.2.2 Power On
POWER
OFF ON
Press "On" side of the power switch.
3.2.3 Screen Display and Operations at Starting Up
When you power on the cabinet, all LEDs in the control panel illuminate. The LEDs are lighted off
after a while and the following contents are displayed in the order below.
1. The "NF" logo mark is displayed for a few seconds or more than 10 seconds.
2. The self check is performed and the result is displayed.
3. Depending on the output function selection setting at power-on, the Continuous function screen,
Sequence function screen, or Simulation function screen is displayed. For detailed information
about the output function selection at power-on setting, see
4.2.10 and 4.3.10 .
4. If the output function selection is set to the Continuous function and the output-on at power-on
setting is on, the output is turned on after the confirmation message to inform that the output is
automatically turned on is displayed for about 10 seconds. If you press the ENTER key while
this message is displayed, you can cancel the setting of automatic output-on. For detailed
information about the output-on at power-on setting, see
4.21 .
3.2.4 The Settings Loaded after Startup
For the Continuous function, the output settings are invoked from the Basic Setting Memory No.1
and other settings are loaded from the System Setting Memory. For details, see
4.8 and 10.24 .
For the Sequence function and the Simulation function, the factory default settings are loaded for the
content of each step.
3.2.5 Checking the Rated Power
On the screen after startup, the rated power icon is displayed in the position shown in Figure 3–5.
The value in the icon indicates the maximum electric power that can be output. In Figure 3–5, the
maximum electric power is 3.0 kVA.
If the rated power is restricted by the power unit energization setting, the icon is highlighted as
shown in Table 3-4. For detailed information about the power unit energization setting, see
4.23 .