One-Net/DASDEC User Manual
5-132
v3.0 | r1016
Expansion GPIO Status Table
Display Expansion GPIO Status
If the EAS device is configured with an internal expanded GPIO card, the
Display
Expanded GPIO Status
check box will appear on this screen and there will be a sub-tab
labeled
Expansion GPIO
within the
Setup > GPIO
menu. Click this check box to view
the Expansion GPIO Table where the status of each GPIO input and output is shown.
Configuration of the Expansion GPIO is performed within the
Setup > GPIO > Expansion
GPIO
sub-tab.
Display Multiplayer GPIO Status
The
Display Multiplayer GPIO Status
check box will appear if the EAS device is
configured with an external MultiPlayer (for MultiStation support). Click this check box
to view the Multiplayer GPIO Table where the status of each GPIO input and output
is shown. Programming of these GPIOs is performed within the Multiplayer sub-tab
within
Setup > GPIO
. To setup a new Multiplayer, go to
Setup > Audio > Multiplayer
.
Configuration of the MultiPlayer is performed on the
Setup > GPIO > Multiplayer GPIO
screen. (See below for more details)
Display Net GPIO Status
If the EAS device is configured with an external Hub Controller / Net GPIO unit, the
Display NET GPIO Status
check box will appear. Click this check box to view the Hub
Controller / Net GPIO Table where the status of each GPIO is shown. To add, delete and
configure a Hub Controller / Net GPIO unit go to
Setup > Net Alerts > Hub Controller /
Net GPIO
screen.
MultiStation Mode
When MultiStation mode is enabled, the configured GPIO outputs are selectable for
each station. A station can choose to NOT use a GPIO output. The station assignment
options do not allow reprogramming of a relay, just its inclusion. This allows specific
GPIO outputs to be assigned to different stations and thereby recognized as triggering
an action because a specific station is active. Configure per station used GPIO output
relays on the proper station interface configuration page under
Setup > Station
and use
the appropriate station sub-tab(s).
Expansion GPIO
When an Expansion GPIO board is installed, the
Expansion GPIO
sub-tab is available
within the
Setup > GPIO
menu. This factory installed option adds 8 more GPIO inputs
and 8 more GPIO outputs. The configuration of these inputs and outputs is performed
in this sub-tab.
