One-Net/DASDEC User Manual
5-78
v3.0 | r1016
Number of repetitions
The Message Display Control option “
Repeat CEM alert play-out for a fixed
number of times”
is for selecting the number of times the CEM alert is re
-
played.
Replay period
The repeat period interface for Message Display Control options that cause
repetition for certain time durations, can set the replay period to the time in
minutes/seconds between end of play-out and replay.
Audio control/ audio repetition control
The pull-down menu allows selection of none, all, or part of the EAS audio
message during the first and repeat play-outs.
Custom MSG Forwarding
The
Decoder NET Access Custom Message Forwarding Options
screen allows a user
to enable EAS NET decode custom message forwarding and gives them control over
how these messages are forwarded. Even in Manual Forwarding Mode, a user can
auto-forward EAS NET decoded custom messages.
NET Decode Custom Message Forwarding
When enabled, it gives the operator the ability to forward decoded messages from
EAS NET. If this option is disabled, custom messages that are decoded over EAS NET
cannot be forwarded.
Custom Message Forwarding Screen
If the EAS device does not have any current active custom message alerts, there will
be a message that says:
No NET access decoded custom messages at this time.
If the EAS device does have a current active custom message alert, that alert will
appear on the right side of the page in red.
If the
NET Decode Custom Message Forwarding
is enabled, more options appear.
Allow message stop from master NET message originator
This option allows the EAS device that sent a custom message via EAS NET to control
when the alert is stopped on the receiving EAS device. If this is not enabled, the user
would manually stop the alert on the receiving EAS device (if it is before the alert is
done).
