Mitsubishi Electric C70, Setup Manual

Page: 210 / 628

C70 Setup Manual
Appendix 1.3 Base Specifications Parameters
193
【
#1169
】
part system name Part system name
Set the name of each part system.
This must be set only when using multi-part system.
This name will be displayed on the screen only when the part systems must be identified.
Use a max. of four alphabetic characters or numerals.
---Setting range---
A max. of four alphabetic characters or numerals.
【
#1170
】
M2name Second miscellaneous code
Set this address code when using the 2nd miscellaneous command. Set an address with A, B or C
that is not used for "#1013 axname" or "#1014 incax".
---Setting range---
A, B, C
【
#1171
】
taprov Tap return override
Set the tap return override value for the synchronous tapping.
When "0" is set, it will be regarded as 100%.
---Setting range---
1 to 100 (%)
【
#1172
】
tapovr Tap return override
Set the override value when leaving the tap end point in the synchronous tapping cycle.
The setting range is 1 to 999, and the unit is %.
When a value less than 100 is set, it will be judged as 100%.
---Setting range---
1 to 999 (%)
【
#1173
】
dwlskp G04 skip condition
Set the skip signal for ending the G04 (dwell) command.
【
#1174
】
skip_F G31 skip speed
Set the feedrate when there is no F command in the program at G31 (skip) command.
---Setting range---
1 to 999999 (mm/min)
【
#1175
】
skip1 G31.1 skip condition
Designate the skip signal in multi-step skip G31.1.
The setting method is same as "#1173".
SKIP3 SKIP2 SKIP1 SKIP0
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Skip when
Setting
Skip signals
signal is input.