Mitsubishi Electric C70, Setup Manual

Page: 212 / 628

C70 Setup Manual
Appendix 1.3 Base Specifications Parameters
195
【
#1185
】
spd_F1 F1 digit feedrate F1
Set the feedrate for the F command in the F 1-digit command ("#1079 F1digit" is set to "1").
Feedrate when F1 is issued (mm/min)
---Setting range---
1 to 1000000 (mm/min)
【
#1186
】
spd_F2 F1 digit feedrate F2
Set the feedrate for the F command in the F 1-digit command ("#1079 F1digit" is set to "1").
Feedrate when F2 is issued (mm/min)
---Setting range---
1 to 1000000 (mm/min)
【
#1187
】
spd_F3 F1 digit feedrate F3
Set the feedrate for the F command in the F 1-digit command ("#1079 F1digit" is set to "1").
Feedrate when F3 is issued (mm/min)
---Setting range---
1 to 1000000 (mm/min)
【
#1188
】
spd_F4 F1 digit feedrate F4
Set the feedrate for the F command in the F 1-digit command ("#1079 F1digit" is set to "1").
Feedrate when F4 is issued (mm/min)
---Setting range---
1 to 1000000 (mm/min)
【
#1189
】
spd_F5 F1 digit feedrate F5
Set the feedrate for the F command in the F 1-digit command ("#1079 F1digit" is set to "1").
Feedrate when F5 is issued (mm/min)
---Setting range---
1 to 1000000 (mm/min)
【
#1190(PR)
】
s_xcnt Validate inclined axis control (for L system only)
Select whether to enable or disable inclined axis control.
0: Disable inclined axis control
1: Enable inclined axis control
【
#1191(PR)
】
s_angl Inclination angle (for L system only)
Set the inclination angle
α
of the oblique coordinate X' axis from X axis on the orthogonal coordinate
system.
---Setting range---
-80.000 to 80.000 (°)
【
#1192(PR)
】
s_zrmv Compensation at reference point return (for L system only)
Select whether to compensate for the Z axis motion during the X axis manual reference position
return under the inclined axis control.
0 : Compensate for Z axis
1 : Not compensate for Z axis