Mitsubishi Electric C70, Setup Manual

Page: 211 / 628

Appendix 1 Explanation of Parameters
MITSUBISHI CNC
194
【
#1176
】
skip1f G31.2 skip speed
Set the skip feedrate in multi-step skip G31.1.
---Setting range---
1 to 999999 (mm/min)
【
#1177
】
skip2 G31.2 skip condition
Set the skip signal in multi-step skip G31.2.
The setting method is same as "#1173".
【
#1178
】
skip2f G31.2 skip speed
Set the skip signal in multi-step skip G31.2.
---Setting range---
1 to 999999 (mm/min)
【
#1179
】
skip3 G31.3 skip condition
Set the skip signal in multi-step skip G31.3
The setting method is same as "#1173".
【
#1180
】
skip3f G31.3 skip speed
Set the skip signal in multi-step skip G31.3.
---Setting range---
1 to 999999 (mm/min)
【
#1181
】
G96_ax Constant surface speed axis
Select the axis to be targeted for constant surface speed control.
0: Program setting will be disabled, and the axis will always be fixed to the 1st axis
1: 1st axis
2: 2nd axis
3: 3rd axis
:
8: 8th axis
However, when set to other than “0”, the priority will be on the program setting.
【
#1182
】
thr_F Thread cutting speed
Set the screw cut up speed when not using chamfering in the thread cutting cycle.
0: Cutting feed clamp feedrate
1 to 60000 mm/min: Setting feedrate
---Setting range---
0 to 60000 (mm/min)
【
#1183
】
clmp_M M code for clamp
Set the M code for C axis clamp in hole drilling cycle.
---Setting range---
0 to 99999999
【
#1184
】
clmp_D Dwelling time after outputting M code for unclamp
Set the dwell time after outputting the M code for C axis unclamp in hole drilling cycle.
---Setting range---
0.000 to 99999.999 (s)