Mitel Inter-Tel Axxess, Administrator'S Manual, Page: 192 / 384

Page 176
System Features
Inter-Tel
®
Axxess
®
Administrator Guide — Issue 11.0, May 2008
User-Programmable Feature Buttons
To return the buttons to default values:
While on- or off-hook, enter the Feature Key Default feature code (395). If off-hook, hang up.
The display shows FEATURE KEYS DEFAULTED.
To program a feature code in a user-programmable button or assign a primary station to
a secondary extension button:
1.
While on-hook, enter the Program Keys feature code (397). Display endpoints show
PRESS THE KEY TO PROGRAM.
2. Press the desired feature or secondary extension button. The display shows the current
feature, station, or speed dial location name and KEY VALUE:
(feature, extension, or
location code) .
3.
Enter the feature code or extension number to be stored under that button. ( If program-
ming the button, only Call Forwarding feature codes 355-358 will be accepted.)
You hear a single progress tone when the programming is completed. Display endpoints
show the newly programmed feature. If you attempt to program a non-programmable
button or enter an invalid code, you will hear repeating reorder tones, and the feature
code assigned to the button will remain unchanged. Display endpoints show NON-
PROGRAMMABLE KEY or FEATURE CODE INVALID.
NOTE:
If you do not enter a feature code before the Long Interdigit timer expires, and
the feature code assigned to the button is not changed.
4. To program other buttons, repeat the procedure.
NOTE:
Speed-dial buttons are programmed using the procedure shown below. Entering an
extension number, using the above instructions, will create a DSS/BLF button for that extension
number, not a speed-dial button (even if the button was previously programmed as a speed-dial
button).
To create a speed-dial location in a user-programmable button:
1.
While on-hook, enter the Program Button feature code (397). Display endpoints show
PRESS THE KEY TO PROGRAM.
2. Press the desired feature button. The display shows the current feature, user, or speed
dial location name and KEY VALUE:
(feature or name) .
3. Enter the Station Speed Dial feature code (382) or the System Speed Dial feature code
(381). The display shows SELECT STN SPEED or SELECT SYS SPEED.
4. Enter the desired speed-dial bin number (0-9 for station, 000-999 for system). The dis-
play shows the current contents of that bin.
5. To program a new number in a station speed-dial bin, follow the instructions given on
page 248 . Administrators can use the procedures on page 38 to program system speed-
dial locations.
FWD