Mitel Inter-Tel Axxess, Administrator'S Manual, Page: 111 / 384

Page 95
System Hardware
Inter-Tel
®
Axxess
®
Administrator Guide — Issue 11.0, May 2008
8-Line IMX AIM Analog Endpoints on Dual Circuits
Termination of a data call may be accomplished in one of three ways:
•
Your data device can hang up. This causes the trunk or intercom channel to be released,
terminating the call to the other data device.
•
The other data device may hang up. When the call is disconnected, the button is
unlit. Depending on the type of device used, the data device may detect the loss of car-
rier and automatically terminate the entire connection. If the data device does not have
this capability, you must manually cause the data device to hang up.
•
The data call can be transferred to an associated endpoint’s primary voice path (releas-
ing the data device) and then disconnected by the endpoint. Note however that the
button will flutter rapidly if the data device does not hang up before the Inactiv-
ity timer expires.
To have the data device disconnect the call:
Use the appropriate commands for the data device to instruct it to hang up. When the call is
disconnected, the
button is unlit.
To transfer the data call back to an associated Inter-Tel endpoint before disconnecting the
call:
While on- or off-hook, press the fluttering button. The button goes off. If
desired, speak to the party at the site of the remote data device. This can only be done if the
modem at the site of the remote data device can be turned off without disconnecting the trunk.
To disconnect:
If off-hook , hang up. If on-hook, press the Speaker button. The button will flutter rap-
idly until the data device hangs up.
8-Line IMX AIM Analog Endpoints on Dual Circuits
If desired, 8-line IMX AIM Analog endpoints can be installed two to a circuit using the Ana-
log Keyset Card (AKSC). To do this, single Analog Keyset Card (AKSC) circuits are desig-
nated as “dual” circuits in System Configuration programming. (Other Inter-Tel endpoint
models cannot be installed two to a circuit.) The designated dual circuit becomes two circuits
that can be programmed individually.
Digital Endpoint Desktop Interface
NOTE:
Your software license must include the appropriate premium feature(s) to use Desktop
Interface and System OAI features.
Desktop Interface is a station-level communications protocol that allows a PC, attached to a
PCDPM on a Model 8560, Model 8520, Executive Display, Professional Display, Standard
Display, or Associate Display, to emulate an Inter-Tel endpoint for call handling. This protocol
will allow devices such as PC endpoints, operators’ consoles, ACD supervisors, and integrated
contact management tools to be developed for the system.
DATA
DATA
DATA
DATA DATA
DATA