Micromeritics Gemini VII 2390a, Operator'S Manual

Page: 281 / 426

Gemini VII Appendix B
239-42828-01 - Nov 2013 B-15
4042- 0.0 cannot be a starting or ending pressure for a geometric progression from
low pressure.
4043- 1.0 cannot be a starting or ending pressure for a geometric progression toward
saturation.
4044- Points in the Langmuir report pressure table lie outside the collected data.
4045- Points in the report pressure table lie outside the collected data.
4046- [file name] could not be opened for reading.
4047- Warning: An error occurred while reading [file name].
Cause: An attempt was made to generate a pressure table from a
geometrically progressing range.
Action: Change the 0.0 entered value.
Cause: An attempt was made to generate a pressure table from a
geometrically progressing range.
Action: Change the 1.0 entered value.
Cause: Calculation assignments are not being used and more than one of the
report pressure table points is above the range of the collected data
and more than one is below.
Action: Change the report pressure table to be more consistent with the
collected data.
Cause: Calculation assignments are not being used and more than one of the
report pressure table points is above the range of the collected data
and more than one is below.
Action: Change the report pressure table to be more consistent with the
collected data.
Cause: A thickness curve file could not be opened.
Action: If the problem persists, restart the computer and optionally perform a
media integrity check (using ScanDisk).
Cause: An error happened during a read operation of a thickness curve file.
Action: If the problem persists, restart the computer and optionally perform a
media integrity check (using ScanDisk).