Micromeritics Gemini VII 2390a, Operator'S Manual

Page: 242 / 426

Preventive Maintenance Gemini VII
9-16 239-42828-01 - Dec 2012
6. Open the clamp and place it around the exhaust port flange and the exhaust filter flange. Swing
the clamp fastening screw toward the exhaust port until it fits into the slot in the other half of the
clamp. Tighten the wing nut securely by hand.
7. Turn the power to the unit on by replacing the plug back into the power source or by turning the
power switch to the ON position.
Performing a Leak Test
A service representative may request that a leak test be performed to determine if there is a system
leak. The service representative may request a copy of the report generated by this test.
The following information is displayed during the test:
• Prompts on preparing the instrument for the test
• Approximate time period of the test
• Prompts in which an operator response is required

1. To start diagnostic testing, go to
Unit [n] > Diagnostics
.
2. Click the down arrow in the
Test
field and select
System Leak Test Rev. [rev]
.
3. Select
Report after test
and
Preview
as the destination. Click
OK
.
4. Click
Next
. Data will be inserted into the window as they are collected.
5. A popup window indicates the test is complete. Click
OK
, then click
Close
.