Mazda 2013 CX-5, Workshop Manual

Page: 42 / 223

DTC C0061:28/C0061:64/C0062:28/C0062:64/C0063:28/C0063:64 [DYNAMIC STABILITY CONTROL (DSC)]
http://am.mazdaserviceinfo.com/emazda/dealersystem/service/esi/en_us/SM/2013/CX5/mv/books/mvw04/html/id0402b2180800.html[1/7/13 9:29:31 AM]
< Previous Next >
2013 - CX-5 - Brakes
DTC C0061:28/C0061:64/C0062:28/C0062:64/C0063:28/C0063:64 [DYNAMIC STABILITY CONTROL (DSC)]
DTCC0061:28, C0061:64, C0062:28,
C0062:64, C0063:28, C0063:64
SAS control module system
DETECTION
CONDITION
NOTE:
The low-G sensor and the yaw rate sensor are built into the SAS control module.
C0061:28, C0061:64
Out-of-specification signal modulation or lateral-G value is detected from the low-G sensor.
C0062:28, C0062:64
Out-of-specification signal modulation or longitudinal-G value is detected from the low-G
sensor.
C0063:28, C0063:64
Out-of-specification signal modulation or yaw rate value is detected from the yaw rate
sensor.
FAIL-SAFE
FUNCTION
C0061:28, C0061:64, C0063:28, C0063:64
Illuminates the TCS/DSC indicator light.
Tire pressure monitoring system warning light illuminates after flashes.
Inhibits the TCS, DSC, roll over mitigation (ROM), and TPMS controls.
C0062:28, C0062:64
Illuminates the ABS warning light
*1
and TCS/DSC indicator light.
Inhibits the ABS
*2
, TCS
*2
, DSC
*2
, roll over mitigation (ROM)
*2
, brake assist control
*2
, and
hill launch assist (HLA) controls.
*1
: Not illuminated depending on malfunction content.
*2
: Enabled depending on malfunction content.
POSSIBLE
CAUSE
SAS control module malfunction
Open or short circuit in the CAN2_H wiring harness between DSC HU/CM terminal S and SAS control module
terminal 3H
Open or short circuit in the CAN2_L wiring harness between DSC HU/CM terminal P and SAS control module
terminal 3I
DSC HU/CM malfunction
Poor connection at connectors (female terminal)