Mazda 2013 CX-5, Workshop Manual

Page: 46 / 223

DTC C0061:54/C0062:54/C0063:54 [DYNAMIC STABILITY CONTROL (DSC)]
http://am.mazdaserviceinfo.com/emazda/dealersystem/service/esi/en_us/SM/2013/CX5/mv/books/mvw04/html/id0402b2901200.html[1/7/13 9:29:35 AM]
STEP INSPECTION ACTION
1
VERIFY INITIALIZATION PROCEDURE
Was the DSC related parts sensor
initialization procedure performed?
YesGo to the next step.
No Perform the DSC related parts sensor
initialization procedure, then go to Step 3.
(See
DSC RELATED PARTS SENSOR
INITIALIZATION PROCEDURE
.)
2
INSPECT SAS CONTROL MODULE MALFUNCTION
Switch the ignition to off.
Using the M-MDS, perform the DTC
inspection for the SAS control
module.
(See
DTC INSPECTION [STANDARD
DEPLOYMENT CONTROL SYSTEM]
.)
(See
DTC INSPECTION [TWO-STEP
DEPLOYMENT CONTROL SYSTEM]
.)
Are any DTCs detected?
YesGo to applicable DTC inspection.
(See
DTC TABLE [STANDARD DEPLOYMENT
CONTROL SYSTEM]
.)
(See
DTC TABLE [TWO-STEP DEPLOYMENT
CONTROL SYSTEM]
.)
No Go to the next step.
3
VERIFY THAT THE SAME DTC IS NOT PRESENT
Clear the DTCs from the memory.
(See
ON-BOARD DIAGNOSIS
[DYNAMIC STABILITY CONTROL
(DSC)]
.)
Are the same DTCs present?
YesRepeat the inspection from Step 1.
If the malfunction recurs, replace the DSC
HU/CM, then go to the next step.
(See
DSC HU/CM REMOVAL/INSTALLATION
.)
No Go to the next step.
4
VERIFY THAT NO OTHER DTCS ARE PRESENT
Are any other DTCs output?
YesGo to the applicable DTC inspection.
(See
ON-BOARD DIAGNOSIS [DYNAMIC
STABILITY CONTROL (DSC)]
.)
No DTC troubleshooting completed.
< Previous Next >
Back to Top
© 2012 Mazda North American Operations, U.S.A.