Mazda 2013 CX-5, Workshop Manual

Page: 53 / 223

DTC C0089:64 [DYNAMIC STABILITY CONTROL (DSC)]
http://am.mazdaserviceinfo.com/emazda/dealersystem/service/esi/en_us/SM/2013/CX5/mv/books/mvw04/html/id0402b2906500.html[1/7/13 9:29:51 AM]
Disconnect the TCS OFF switch.
Disconnect the instrument cluster connector.
Inspect for continuity between the TCS OFF switch
connector terminal B (vehicle harness-side) and body
ground.
Is there continuity?
wiring harness, then go to
Step 5.
No Go to the next step.
3
INSPECT TCS OFF SWITCH SIGNAL CIRCUIT FOR OPEN CIRCUIT
Inspect for continuity between the TCS OFF switch
connector terminal C (vehicle harness-side) and instrument
cluster connector terminal T (vehicle harness-side).
Is there continuity?
YesGo to the next step.
No Repair or replace the
wiring harness, then go to
Step 5.
4
INSPECT TCS OFF SWITCH
Inspect the TCS OFF switch.
(See
TCS OFF SWITCH INSPECTION
.)
Is the TCS OFF switch normal?
YesGo to the next step.
No Replace the TCS OFF
switch, then go to the
next step.
(See
TCS OFF SWITCH
REMOVAL/INSTALLATION
.)
5
VERIFY THAT THE SAME DTC IS NOT PRESENT
Reconnect all disconnected connectors.
Clear the DTCs from the memory.
(See
ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL
(DSC)]
.)
Are the same DTCs present?
YesRepeat the inspection
from Step 1.
No Go to the next step.
6
VERIFY THAT NO OTHER DTCS ARE PRESENT
Are any other DTCs output?
YesGo to the applicable DTC
inspection.
(See
ON-BOARD
DIAGNOSIS [DYNAMIC
STABILITY CONTROL
(DSC)]
.)
No DTC troubleshooting
completed.
< Previous Next >
Back to Top
© 2012 Mazda North American Operations, U.S.A.