PRECAUTION [DYNAMIC STABILITY CONTROL (DSC)]
http://am.mazdaserviceinfo.com/emazda/dealersystem/service/esi/en_us/SM/2013/CX5/mv/books/mvw04/html/id0403b2804100.html[1/7/13 9:31:20 AM]
malfunction. Some of the things to check for are:
Connectors not fully seated.
Wire harnesses not having full play.
Wires laying across brackets or moving parts.
Wires routed too close to hot parts.
An improperly routed, improperly clamped, or loose harness can cause wiring to become
pinched between parts.
The connector joints, points of vibration, and places where wire harnesses pass through
the firewall, body panels, etc. are the major areas to be checked.
Inspection method for switch and/or sensor connectors or wires
1. Connect the M-MDS (IDS) to the DLC-2.
2. Switch the ignition to ON (engine off).
NOTE:
If the engine starts and runs, perform the following steps at idle.
3. Access PIDs for the switch or sensor you are inspecting.
4. Turn the switch on manually.
5. Slightly shake each connector or wiring harness vertically and horizontally while monitoring
the PID.
If the PID value is unstable, inspect for poor connection.
Inspection method for switches and/or sensors
1. Connect the M-MDS (IDS) to the DLC-2.
2. Switch the ignition to ON (engine off).
NOTE:
