Mazda 2013 CX-5, Workshop Manual

Page: 38 / 223

DTC C0044:01/C0044:28/C0044:54/C0044:64 [DYNAMIC STABILITY CONTROL (DSC)]
http://am.mazdaserviceinfo.com/emazda/dealersystem/service/esi/en_us/SM/2013/CX5/mv/books/mvw04/html/id0402b2888500.html[1/7/13 9:29:19 AM]
Inhibits the TCS
*
, DSC
*
, roll over mitigation (ROM)
*
, brake
assist control
*
, hill launch assist (HLA)
*
, and TPMS
*
controls.
*
: Enabled depending on malfunction content.
POSSIBLE
CAUSE
The initialization procedure for the brake fluid pressure sensor has not been
performed.
Brake fluid pressure sensor malfunction
Open or short circuit in the brake fluid pressure sensor circuit in DSC HU/CM
SYSTEM
WIRING
DIAGRAM
—
Diagnostic procedure
STEP INSPECTION ACTION
1
VERIFY INITIALIZATION PROCEDURE
Was the brake fluid pressure
sensor initialization procedure
been performed?
YesGo to the next step.
No Perform the brake fluid pressure sensor
initialization procedure, then go to the next
step.
(See
DSC RELATED PARTS SENSOR
INITIALIZATION PROCEDURE
.)
2
VERIFY NO ABNORMALITY ON BRAKE FLUID
PRESSURE SENSOR
Clear the DTCs from the memory.
(See
ON-BOARD DIAGNOSIS
[DYNAMIC STABILITY CONTROL
(DSC)]
.)
Start the engine and drive the
vehicle at 10 km/h {6.2 mph}
or more .
Are the same DTCs present?
YesReplace the DSC HU/CM, then go to the next
step.
(See
DSC HU/CM REMOVAL/INSTALLATION
.)
No Go to the next step.
3
VERIFY THAT NO OTHER DTCS ARE PRESENT
Are any other DTCs output?
YesGo to the applicable DTC inspection.
(See
ON-BOARD DIAGNOSIS [DYNAMIC
STABILITY CONTROL (DSC)]
.)
No DTC troubleshooting completed.