NO.2 ANY OF THE FOLLOWING LIGHTS STAY ON: (ABS WARNING LIGHT, TCS/DSC INDICATOR LIGHT AND/OR TCS OFF INDICATOR LIGHT) [...
http://am.mazdaserviceinfo.com/emazda/dealersystem/service/esi/en_us/SM/2013/CX5/mv/books/mvw04/html/id0403b2895700.html[1/7/13 9:31:38 AM]
2013 - CX-5 - Brakes
NO.2 ANY OF THE FOLLOWING LIGHTS STAY ON: (ABS WARNING LIGHT, TCS/DSC INDICATOR
LIGHT AND/OR TCS OFF INDICATOR LIGHT) [DYNAMIC STABILITY CONTROL (DSC)]
2
Any of the following lights stay on: (ABS warning light, TCS/DSC indicator light and/or TCS OFF
indicator light)
POSSIBLE
CAUSE
No connection at DSC HU/CM connector (When DSC HU/CM connector comes
off, ABS warning light, brake system warning light, TCS/DSC indicator light,
and TCS OFF indicator light illuminate.)
DSC HU/CM detected malfunction. (Input and output device malfunction)
DSC HU/CM detects low voltage in power supply.
DSC HU/CM ground malfunction (When DSC HU/CM ground is not securely
connected, ABS warning light, brake system warning light, TCS/DSC indicator
light, and TCS OFF indicator light illuminate but diagnostic trouble code does
not display.)
DSC HU/CM does not operate.
PCM detected malfunction.
Error signal input from PCM
Communication error between DSC HU/CM and instrument cluster
Communication error between DSC HU/CM and PCM
Communication error between DSC HU/CM and EPS CM
After replacing SAS control module low-G sensor and yaw rate sensor
initialization have not been performed.
After replacing DSC HU/CM brake fluid pressure sensor initialization has not
been performed.
Non-completion of module configuration (When module configuration does not
carried out, after replacing DSC HU/CM, ABS warning light will stay on.)
DSC HU/CM internal malfunction
Diagnostic procedure
STEP
INSPECTION
ACTION
CONFIRM DSC HU/CM DTC
