Mazda 2013 CX-5, Workshop Manual

Page: 47 / 223

DTC C0062:76 [DYNAMIC STABILITY CONTROL (DSC)]
http://am.mazdaserviceinfo.com/emazda/dealersystem/service/esi/en_us/SM/2013/CX5/mv/books/mvw04/html/id0402b2901000.html[1/7/13 9:29:40 AM]
< Previous Next >
2013 - CX-5 - Brakes
DTC C0062:76 [DYNAMIC STABILITY CONTROL (DSC)]
DTC C0062:76 SAS control module system
DETECTION
CONDITION
Error is detected in communication with SAS control module by CAN
communication (CAN2).
FAIL-SAFE
FUNCTION
Illuminates the ABS warning light
*1
and TCS/DSC indicator light.
Tire pressure monitoring system warning light illuminates after flashes.
(Not illuminated/flashed depending on malfunction content.)
Inhibits the ABS
*2
, TCS
*2
, DSC
*2
, roll over mitigation (ROM)
*2
, brake
assist control
*2
, hill launch assist (HLA), and TPMS
*2
controls.
*1
: Not illuminated depending on malfunction content.
*2
: Enabled depending on malfunction content.
POSSIBLE
CAUSE
Poor SAS control module installation
Low-G sensor malfunction in SAS control module
STEP INSPECTION ACTION
1
VERIFY IF SAS CONTROL MODULE IS CORRECTLY
INSTALLED
Verify the SAS control module installation
condition.
(See
SAS CONTROL MODULE
REMOVAL/INSTALLATION [STANDARD
DEPLOYMENT CONTROL SYSTEM]
.)
(See
SAS CONTROL MODULE
REMOVAL/INSTALLATION [TWO-STEP
DEPLOYMENT CONTROL SYSTEM]
.)
Is the installation condition normal?
YesGo to the next step.
No Install the SAS control module
correctly, then go to the next step.
2
INSPECT SAS CONTROL MODULE MALFUNCTION
YesGo to applicable DTC inspection.