215015
107
Revision A
1022623
A
B
Figure 4.39: Swath Compressor Switch
9.
Press switch (B) on console to raise swath compressor.
•
CALIBRATING SWATH is displayed on upper line.
•
FORM UP and flashing HOLD is displayed on lower line
until system has completed reading signal with swath
compressor fully raised.
•
SWATH FORM UP and DONE (with buzzer) is displayed
on lower line when complete.
•
SWATH SENSOR CAL is displayed on upper line.
•
PRESS SWATH DOWN is displayed on lower line.
10. Press switch (A) on console to lower swath compressor.
•
CALIBRATING SWATH is displayed on upper line.
•
FORM DOWN and HOLD is displayed on lower line.
•
SWATH FORM COMPLETE flashes for 2 seconds on
lower line (with buzzer) when calibration is finished.
1009099
CXXX
MXXX
WINDROWER SETUP?
NO/YES
A
B
Figure 4.40: CDM Programming Buttons
11. Press PROGRAM (A) to exit programming mode or press
SELECT (B) to proceed to next windrower setup action.
4.3.12
Activating the Hay Conditioner
NOTE:
•
This procedure is for draper headers only.
•
The header
MUST
be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header.