215015
126
Revision A
4.6.2
Calibrating the Header Tilt Sensor
NOTE:
•
The header
MUST
be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header.
•
This procedure requires installation of the optional Hydraulic Center-Link (MD #B4650).
•
The engine
MUST
be running to perform this procedure.
1009099
CXXX
MXXX
WINDROWER SETUP?
NO/YES
A
B
Figure 4.83: CDM Programming Buttons
1.
Start the engine.
2.
Press PROGRAM (A) and SELECT (B) on cab display module
(CDM) to enter programming mode.
•
WINDROWER SETUP? is displayed on the upper line.
3.
Press SELECT (B) until CALIBRATE SENSORS? is displayed on
the upper line.
•
NO/YES is displayed on the lower line.
1018666
HDR TILT SENSOR CAL
EXTEND TILT TO START
CXXX
MXXX
C
B
A
Figure 4.84: Header Tilt
4.
Press right arrow (B) to select YES. Press SELECT (C).
•
TO CALIBRATE SELECT is displayed in upper line.
5.
Press left (A) or right (B) arrow until HEADER TILT is
displayed on the lower line. Press SELECT (C).
•
HDR TILT SENSOR CAL is displayed on the upper line.
•
EXTEND TILT TO START is displayed on the lower line.
