215015
125
Revision A
1023539
A
Figure 4.81: Header Height Controls on GSL
CAUTION
Check to be sure all bystanders have cleared the area.
6.
Press and hold the HEADER UP button (A) on the ground
speed lever (GSL).
•
CALIBRATING HEIGHT is displayed on the upper line.
•
RAISE HEADER HOLD is displayed on the lower line.
NOTE:
The word HOLD will flash during calibration. RAISE HEADER
DONE will display on the lower line once calibration is
complete.
7.
Release the HEADER UP button (A).
•
HEIGHT SENSOR CAL is displayed on the upper line.
•
PRESS LOWER HEADER is displayed on the lower line.
1023540
A
Figure 4.82: Header Height Controls on GSL
8.
Press and hold HEADER DOWN button (A) on the GSL.
NOTE:
The word HOLD will flash during calibration. HT SENSOR
COMPLETE will display on the lower line once calibration is
complete.
9.
Release HEADER DOWN button (A).
•
TO CALIBRATE SELECT is displayed on the upper line.
•
HEADER HEIGHT is displayed on the lower line.
10. Press right arrow to select next header sensor calibration or
STOP & EXIT. Press SELECT.
11. Press PROGRAM to exit programming mode.
