215015
174
Revision A
1000767
A
B
Figure 6.8: Header Leg and Boot
5.
Drive the windrower slowly forward until boots (A) enter
header legs (B). Continue driving slowly forward until the
lift linkages contact the support plates in the header legs
and the header nudges forward.
6.
Ensure the lift linkages are properly engaged in the header
legs and are contacting the support plates.
1008944
A
B
C
D
Figure 6.9: Ground Speed Lever
7.
Use the following GSL functions to position the center-link
hook above the header attachment pin:
•
REEL UP (A) to raise the center-link
•
REEL DOWN (B) to lower the center-link
•
HEADER TILT UP (C) to retract the center-link
•
HEADER TILT DOWN (D) to extend the center-link
1029715
A
B
Figure 6.10: Hydraulic Center-Link
8.
Adjust position of center-link cylinder (A) with the REEL UP,
REEL DOWN, AND HEADER TILT switches on the GSL until
the hook is above the header attachment pin.
IMPORTANT:
Hook release must be down to enable self-locking
mechanism. If the release is open (up), manually push it
down after hook engages header pin.
9.
Lower center-link (A) onto the header with the REEL DOWN
switch on the GSL until it locks into position (hook
release [B] is down).
10. Check that center-link is locked onto header by pressing the
REEL UP switch on the GSL.
CAUTION
Check to be sure all bystanders have cleared the area.
