215015
105
Revision A
4.3.10
Setting the Header Cut Width
The header sends an electrical signal to the windrower to produce a header ID; however, the cut width will always default
to the smallest header size available for each header type. For example, A Series Auger Headers come in 4.3, 4.9, and 5.5 m
(14, 16, and 18 ft.) sizes, but the cut width will default to 4.3 m (14 ft.). Adjust setting to your specific header size.
NOTE:
•
The header
MUST
be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header.
•
Header cut width is set to less than the actual header width in order to accurately measure the number of acres cut.
1.
Turn ignition key to RUN, or start the engine.
1009066
CXXX
MXXX
WINDROWER SETUP?
NO/YES
A
B
C
Figure 4.35: CDM Programming Buttons
2.
Press PROGRAM (A) and SELECT (C) on the cab display
module (CDM) to enter programming mode.
•
WINDROWER SETUP? is displayed on the upper line.
•
NO/YES is displayed on the lower line.
3.
Press right arrow (B) to select YES. Press SELECT (C).
•
SET KNIFE SPEED? is displayed.
1009101
CXXX
MXXX
HDR CUT WIDTH? 0101
20.5 FEET
D
C
B
A
Figure 4.36: Header Cut Width
4.
Press SELECT (D) until HDR CUT WIDTH? #### is displayed
on the upper line.
•
Previous cutting width is displayed on the lower line.
5.
Press left (B) or right (C) arrows to change the header cut
width. Press SELECT (D).
6.
Press PROGRAM (A) to exit programming mode or press
SELECT (D) to proceed to next WINDROWER SETUP action.
