215015
102
Revision A
1009066
CXXX
MXXX
WINDROWER SETUP?
NO/YES
A
B
C
Figure 4.27: M155 CDM Programming Buttons Shown
2.
Press PROGRAM (A) and SELECT (C) on the cab display
module (CDM) to enter programming mode.
•
WINDROWER SETUP? is displayed on the upper line.
•
NO/YES is displayed on the lower line.
3.
Press right arrow (B) to select YES. Press SELECT (C).
•
SET KNIFE SPEED? is displayed.
1009098
RETURN TO CUT MODE
CXXX
MXXX
HEIGHT & TILT
D
C
B
A
Figure 4.28: M155 Return to Cut Mode Shown
4.
Press SELECT (D) until RETURN TO CUT MODE? is displayed
on the upper line.
•
HEIGHT & TILT or HEIGHT ONLY will be displayed on the
lower line.
5.
Press left (B) or right (C) arrows to select RETURN TO CUT
MODE. Press SELECT (D).
6.
Press PROGRAM (A) to exit programming mode or press
SELECT (D) to proceed to next WINDROWER SETUP action.
4.3.7
Setting the Auto Raise Height
Auto Raise Height allows the Operator to raise the header to a preset height by double-clicking the HEADER UP switch on
the ground speed lever.
NOTE:
The header
MUST
be attached to the windrower to perform this procedure. The cab display module (CDM) automatically
adjusts its programming for each header.
