215015
103
Revision A
1009066
CXXX
MXXX
WINDROWER SETUP?
NO/YES
A
B
C
Figure 4.29: CDM Programming Buttons
1.
Turn ignition key to RUN, or start the engine.
2.
Press PROGRAM (A) and SELECT (C) on the cab display
module (CDM) to enter programming mode.
•
WINDROWER SETUP? is displayed on the upper line.
•
NO/YES is displayed on the lower line.
3.
Press right arrow (B) to select YES. Press SELECT (C).
•
SET KNIFE SPEED? is displayed on the upper line.
1009259
CXXX
MXXX
AUTO RAISE HEIGHT?
4.0
D
C
B
A
Figure 4.30: M155 Auto Raise Height Shown
4.
Press SELECT (D) until AUTO RAISE HEIGHT? is displayed on
the upper line.
•
Last measurement is displayed on the lower line.
NOTE:
The auto raise height ranges from 4.0 (minimum) to
9.5 (maximum), in 0.5 increments. A setting of 10 disables
the auto raise function.
5.
Press left arrow (B) or right arrow (C) to change auto raise
height.
6.
Press PROGRAM (A) to exit programming mode or press
SELECT (D) to proceed to next WINDROWER SETUP action.
4.3.8
Activating the Hydraulic Center-Link
NOTE:
This procedure requires installation of the optional Hydraulic Center-Link (MD #B4650).
1009066
CXXX
MXXX
WINDROWER SETUP?
NO/YES
A
B
C
Figure 4.31: CDM Programming Buttons
1.
Turn ignition key to RUN, or start the engine. For
instructions, refer to
3.18.10 Starting Engine, page 80
2.
Press PROGRAM (A) and SELECT (C) on the cab display
module (CDM) to enter programming mode.
•
WINDROWER SETUP? is displayed on the upper line.
•
NO/YES is displayed on the lower line.
3.
Press right arrow (B) to select YES. Press SELECT (C).
•
SET KNIFE SPEED? is displayed on the upper line.
