215015
142
Revision A
1009330
CXXX
MXXX
ACTIVATE FUNCTIONS?
NO/YES
B
A
Figure 4.121: Functions
5.
Press SELECT (B) until ACTIVATE FUNCTIONS? is displayed
on the upper line.
•
NO/YES is displayed on the lower line.
6.
Press right arrow (A) to select YES. Press SELECT (B).
1009297
CXXX
MXXX
ACTIVATE HDR TILT
IN/OUT
D
C
B
A
Figure 4.122: Header Tilt Angle
7.
Press SELECT (D) until ACTIVATE HDR TILT is displayed on
the upper line.
•
IN/OUT is displayed on the lower line.
8.
Press and hold left arrow (B) to
decrease
header tilt. Press
and hold right arrow (C) to
increase
header tilt.
IMPORTANT:
Verify header is functioning properly.
9.
Press PROGRAM (A) to exit programming mode or press
SELECT (D) to proceed to next ACTIVATE FUNCTION.
4.9.4
Testing the Knife Drive Circuit Using the Cab Display Module
IMPORTANT:
Do
NOT
overspeed a drive. Overspeeding can lead to vibration, belt failures, or other overspeeding related problems.
NOTE:
The header
MUST
be attached to windrower to follow this procedure.
1009099
CXXX
MXXX
WINDROWER SETUP?
NO/YES
A
B
Figure 4.123: CDM Programming Buttons
1.
Start the engine.
2.
Press PROGRAM (A) and SELECT (B) on cab display module
(CDM) to enter programming mode. Press SELECT (B).
•
WINDROWER SETUP? is displayed on the upper line.
