215015
115
Revision A
1009236
CXXX
MXXX
HEADER FLOAT
ENABLED/LOCKED
D
C
B
A
Figure 4.56: Header Float Control Lock
6.
Press SELECT (D) until HEADER FLOAT is displayed on the
upper line.
•
ENABLED/LOCKED is displayed on the lower line.
7.
Press left arrow (B) to enable HEADER FLOAT control
switch, or press right arrow (C) to lock HEADER FLOAT
control switch.
8.
Press PROGRAM (A) to exit programming mode or press
SELECT (D) to proceed to next WINDROWER SETUP action.
4.4.3
Activating the Reel Fore-Aft Control Lockout
NOTE:
•
This procedure is for draper headers only.
•
The header
MUST
be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header.
1009066
CXXX
MXXX
WINDROWER SETUP?
NO/YES
A
B
C
Figure 4.57: CDM Programming Buttons
1.
Turn ignition key to RUN, or start the engine.
2.
Press PROGRAM (A) and SELECT (C) on the cab display
module (CDM) to enter programming mode.
•
WINDROWER SETUP? is displayed on the upper line.
•
NO/YES is displayed on the lower line.
3.
Press right arrow (B) to select YES. Press SELECT (C).
•
SET KNIFE SPEED? is displayed on the upper line.
1009221
CXXX
MXXX
NO/YES
SET CONTROL LOCKS?
B
A
Figure 4.58: Control Locks
4.
Press SELECT (B) until SET CONTROL LOCKS? is displayed on
the upper line.
•
NO/YES is displayed on the lower line.
5.
Press right arrow (A) to select YES. Press SELECT (B).
