215015
118
Revision A
1009226
CXXX
MXXX
AUGER SPEED
ENABLED/LOCKED
D
C
B
A
Figure 4.65: Auger Control Lock
6.
Press SELECT (D) until AUGER SPEED is displayed on the
upper line.
•
ENABLED/LOCKED is displayed on the lower line.
7.
Press left arrow (B) to enable AUGER SPEED control switch.
Press right arrow (C) to lock AUGER SPEED control switch.
8.
Press PROGRAM (A) to exit programming mode, or press
SELECT (D) to proceed to next WINDROWER SETUP action.
4.4.6
Activating Knife Speed Control Lockout
NOTE:
The header
MUST
be attached to the windrower to perform this procedure. The cab display module (CDM) automatically
adjusts its programming for each header.
1009066
CXXX
MXXX
WINDROWER SETUP?
NO/YES
A
B
C
Figure 4.66: CDM Programming Buttons
1.
Turn ignition key to RUN, or start the engine.
2.
Press PROGRAM (A) and SELECT (C) on the cab display
module (CDM) to enter programming mode.
•
WINDROWER SETUP? is displayed on the upper line.
•
NO/YES is displayed on the lower line.
3.
Press right arrow (B) to select YES. Press SELECT (C).
•
SET KNIFE SPEED? is displayed on the upper line.
1009221
CXXX
MXXX
NO/YES
SET CONTROL LOCKS?
B
A
Figure 4.67: Control Locks
4.
Press SELECT (B) until SET CONTROL LOCKS? is displayed on
the upper line.
•
NO/YES is displayed on the lower line.
5.
Press right arrow (A) to select YES. Press SELECT (B).