215015
184
Revision A
Attaching a D Series or D1 Series Header: Mechanical Center-Link
NOTE:
Draper header boots must be installed onto the windrower lift linkage before starting this procedure. Refer to
Attaching Header Boots, page 171
WARNING
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove the key
from the ignition before leaving the operator
’
s seat for any reason.
1.
Shut down the engine, and remove the key from the ignition.
1000754
A
B
Figure 6.33: Header Leg
2.
Remove hairpin (A) from pins (B), and remove pins from
both header legs.
1008925
A
Figure 6.34: Ground Speed Lever
CAUTION
Check to be sure all bystanders have cleared the area.
IMPORTANT:
Before starting engine, remove protective cover from
exhaust stack.
3.
Start the engine and activate HEADER DOWN button (A) on
the ground speed lever (GSL) to fully retract header lift
cylinders.
