215015
97
Revision A
4.3
Configuring the Windrower
The windrower can be configured to meet changing crop conditions, activate newly added options, indicate a change of
header type, or increase operator comfort level.
4.3.1
Setting the Header Knife Speed
This topic does not apply to rotary disc headers.
NOTE:
The header
MUST
be attached to the windrower to perform this procedure. The cab display module (CDM) automatically
adjusts its programming for each header.
1009066
CXXX
MXXX
WINDROWER SETUP?
NO/YES
A
B
C
Figure 4.17: CDM Programming Buttons
1.
Turn ignition key to RUN, or start the engine.
2.
Press PROGRAM (A) and SELECT (C) on the cab display
module (CDM) to enter programming mode.
•
WINDROWER SETUP? is displayed on the upper line.
•
NO/YES is displayed on the lower line.
3.
Press right arrow (B) to select YES. Press SELECT (C).
•
SET KNIFE SPEED? is displayed.
•
The current knife speed is displayed on the lower line.
1009144
CXXX
MXXX
SET KNIFE SPEED
#### SPM
D
C
B
A
Figure 4.18: Knife Speed
4.
Press left (B) or right (C) arrows to select knife speed. Press
SELECT (D).
5.
Press PROGRAM (A) to exit programming mode or press
SELECT (D) to proceed to next WINDROWER SETUP action.