215015
113
Revision A
4.4
Activating Cab Display Lockouts
You can lock some of the header functions controlled by the cab display module (CDM) to prevent accidental changes to
header settings. You can use this feature to keep header settings constant when several different Operators use the
windrower.
NOTE:
FUNCTION LOCKED flashes on CDM when locked header function switch is pressed.
4.4.1
Activating the Header Tilt Control Lockout
NOTE:
•
The header
MUST
be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header.
•
This procedure requires installation of the optional Hydraulic Center-Link (MD #B4650).
1009066
CXXX
MXXX
WINDROWER SETUP?
NO/YES
A
B
C
Figure 4.51: CDM Programming Buttons
1.
Turn ignition key to RUN, or start the engine.
2.
Press PROGRAM (A) and SELECT (C) on the cab display
module (CDM) to enter programming mode.
•
WINDROWER SETUP? is displayed on the upper line.
•
NO/YES is displayed on the lower line.
3.
Press right arrow (B) to select YES. Press SELECT (C).
•
SET KNIFE SPEED? is displayed on the upper line.
1009221
CXXX
MXXX
NO/YES
SET CONTROL LOCKS?
B
A
Figure 4.52: Control Locks
4.
Press SELECT (B) until SET CONTROL LOCKS? is displayed on
the upper line.
•
NO/YES is displayed on the lower line.
5.
Press right arrow (A) to select YES. Press SELECT (B).
