215015
109
Revision A
4.3.13
Displaying Reel Speed
NOTE:
•
This procedure is for draper and auger headers. It does not apply to rotary disc headers.
•
The header
MUST
be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header.
1009066
CXXX
MXXX
WINDROWER SETUP?
NO/YES
A
B
C
Figure 4.43: CDM Programming Buttons
1.
Turn ignition key to RUN, or start the engine.
2.
Press PROGRAM (A) and SELECT (C) on CDM to enter
programming mode.
•
WINDROWER SETUP? is displayed on the upper line.
•
NO/YES is displayed on the lower line.
3.
Press right arrow (B) to select YES. Press SELECT (C).
•
SET KNIFE SPEED? is displayed on the upper line.
1009105
CXXX
MXXX
HEADER REEL SPEED
RPM/MPH
D
C
B
A
Figure 4.44: Reel Speed Display
4.
Press SELECT (D) until HEADER REEL SPEED? is displayed on
the upper line.
•
RPM/MPH or RPM/KPH is displayed on the lower line.
5.
Press left (B) or right (C) arrow to select either IMPERIAL or
METRIC units. Press SELECT (D).
6.
Press PROGRAM (A) to exit programming mode or press
SELECT (D) to proceed to next WINDROWER SETUP action.
