215015
104
Revision A
1009072
CXXX
MXXX
TILT CYL INSTALLED?
NO/YES
C
B
A
Figure 4.32: CDM Programming Buttons
4.
Press SELECT (C) until TILT CYL INSTALLED? is displayed on
the upper line.
•
NO/YES is displayed on the lower line.
5.
Press right arrow (B) to select YES. Press SELECT (C).
6.
Press PROGRAM (A) to exit programming mode or press
SELECT (C) to proceed to next WINDROWER SETUP action.
4.3.9
Activating the Rotary Header Drive Hydraulics
NOTE:
This procedure requires installation of the optional Rotary Header Drive Hydraulics (MD #B5510).
For more information, refer to the rotary disc header operator
’
s manual.
1009066
CXXX
MXXX
WINDROWER SETUP?
NO/YES
A
B
C
Figure 4.33: CDM Programming Buttons
1.
Turn ignition key to RUN, or start the engine. For
instructions, refer to
3.18.10 Starting Engine, page 80
2.
Press PROGRAM (A) and SELECT (C) on the cab display
module (CDM) to enter programming mode.
•
WINDROWER SETUP? is displayed on the upper line.
•
NO/YES is displayed on the lower line.
3.
Press right arrow (B) to select YES. Press SELECT (C).
•
SET KNIFE SPEED? is displayed on the upper line.
1018151
CXXX
MXXX
DISC BLK INSTALLED?
NO/YES
A
B
C
Figure 4.34: Rotary Disc Hydraulics
4.
Press SELECT (C) until DISC BLK INSTALLED? is displayed on
the upper line.
•
NO/YES is displayed on the lower line.
5.
Press right arrow (B) to select YES. Press SELECT (C).
6.
Press PROGRAM (A) to exit programming mode or press
SELECT (C) to proceed to next WINDROWER SETUP action.
