215015
122
Revision A
4.5
Displaying Activated Cab Display Lockouts
Displaying the activated control locks allows you to quickly determine which controls are locked on the cab display
module (CDM).
NOTE:
Displaying header tilt control lock requires installation of the optional Hydraulic Center-Link (MD #B4650).
1009066
CXXX
MXXX
WINDROWER SETUP?
NO/YES
A
B
C
Figure 4.75: CDM Programming Buttons
1.
Turn ignition key to RUN, or start the engine.
2.
Press PROGRAM (A) and SELECT (C) on the cab display
module (CDM) to enter programming mode.
•
WINDROWER SETUP? is displayed on the upper line.
•
NO/YES is displayed on the lower line.
3.
Press right arrow (B) to select YES. Press SELECT (C).
•
SET KNIFE SPEED? is displayed on the upper line.
1009243
CXXX
MXXX
VIEW CONTROL LOCKS
NO/YES
B
A
Figure 4.76: Control Locks
4.
Press SELECT (B) until VIEW CONTROL LOCKS? is displayed
on the upper line.
•
NO/YES is displayed on the lower line.
5.
Press right arrow (A) to select YES. Press SELECT (B).
HEADER TILT is displayed on the upper line.
•
The control switch status is displayed on the lower line.
The hours displayed indicate when a switch was
enabled or locked.
1009247
CXXX
MXXX
DRAPER SPEED
575.1 HRS ENABLED
D
C
B
A
Figure 4.77: Control Locks
6.
Press left arrow (B) or right arrow (C) to cycle between
control switch lockouts. The displayed control switches are
as follows:
•
HEADER TILT
•
HEADER FLOAT
•
REEL FORE/AFT
•
DRAPER SPEED
•
AUGER SPEED
•
KNIFE SPEED
•
DISK SPEED
•
REEL SPEED
