215015
116
Revision A
1009230
CXXX
MXXX
REEL FORE/AFT
ENABLED/LOCKED
D
C
B
A
Figure 4.59: Reel Fore-Aft Control Lock
6.
Press SELECT (D) until REEL FORE/AFT is displayed on the
upper line.
•
ENABLED/LOCKED is displayed on the lower line.
7.
Press left arrow (B) to enable REEL FORE/AFT control
switch.
Press right arrow (C) to lock REEL FORE/AFT control switch.
8.
Press PROGRAM (A) to exit programming mode, or press
SELECT (D) to proceed to next WINDROWER SETUP action.
4.4.4
Activating the Draper Speed Control Lockout
NOTE:
•
This procedure is for draper headers only.
•
The header
MUST
be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header.
1009066
CXXX
MXXX
WINDROWER SETUP?
NO/YES
A
B
C
Figure 4.60: CDM Programming Buttons
1.
Turn ignition key to RUN, or start the engine.
2.
Press PROGRAM (A) and SELECT (C) on the cab display
module (CDM) to enter programming mode.
•
WINDROWER SETUP? is displayed on the upper line.
•
NO/YES is displayed on the lower line.
3.
Press right arrow (B) to select YES. Press SELECT (C).
•
SET KNIFE SPEED? is displayed on the upper line.
1009221
CXXX
MXXX
NO/YES
SET CONTROL LOCKS?
B
A
Figure 4.61: Control Locks
4.
Press SELECT (B) until SET CONTROL LOCKS? is displayed on
the upper line.
•
NO/YES is displayed on the lower line.
5.
Press right arrow (A) to select YES. Press SELECT (B).
