
215015
81
Revision A
d.
Turn ignition key (B) to START position until engine
starts and then release the key. The tone will cease and
warning lights will go out.
WARNING
If starter engages with steering wheel unlocked, ground speed lever out of NEUTRAL, or header clutch engaged, do NOT
start engine. Refer to the technical manual.
NOTE:
When starting engine in temperatures below 5°C (40°F), engine will cycle through a period when it appears to labour
during engine warm-up. The throttle is nonresponsive while engine is in warm-up mode. Warm-up mode lasts between 30
seconds and 3 minutes depending on the temperature. The throttle will become active after the engine has stabilized and
is idling normally.
IMPORTANT:
Do
NOT
operate engine above 1500 rpm until engine temperature gauge is above 40°C (100°F).
IMPORTANT:
•
Do
NOT
operate starter for longer than 15 seconds at a time.
•
If engine does
NOT
start, wait at least 2 minutes before trying again.
•
After the third 15-second crank attempt, allow the starter motor to cool for 10 minutes before further cranking
attempts.
•
If engine still does
NOT
start, refer to Table
Cold start:
NOTE:
Engines are equipped with cold start assist system.
7.
When the engine temperature is below 5°C (40°F), follow the procedure for a normal start. Refer to Step
,
but adhere to the following
NOTE
and
IMPORTANT
statements while starting the engine.
NOTE:
Engine will cycle through a period when it appears to labour during engine warm up. The throttle is nonresponsive
while engine is in warm up mode. Warm up mode lasts between 30 seconds and 3 minutes depending on the
temperature. The throttle will become active after the engine has stabilized and is idling normally.
IMPORTANT:
Do
NOT
operate engine above 1500 rpm until engine temperature is above 40°C (100°F).
Table 3.4 Engine Start Troubleshooting
Problem
Solution
Controls not in NEUTRAL
•
Move GSL to NEUTRAL
•
Move steering wheel to locked (centered) position
•
Disengage HEADER switch
Operator
’
s station not locked
•
Adjust position of operator
’
s station
•
Ensure lock is engaged
Neutral interlock misadjusted
•
Refer to the windrower technical manual
No fuel to engine
•
Fill empty fuel tank