215015
114
Revision A
1009232
CXXX
MXXX
HEADER TILT
ENABLED/LOCKED
D
C
B
A
Figure 4.53: Header Tilt Control Lock
6.
Press SELECT (D) until HEADER TILT is displayed on the
upper line.
•
ENABLED/LOCKED is displayed on the lower line.
7.
Press left arrow (B) to enable the HEADER TILT control
switch.
Press right arrow (C) to lock the HEADER TILT control
switch.
8.
Press PROGRAM (A) to exit programming mode, or press
SELECT (D) to proceed to next WINDROWER SETUP action.
4.4.2
Activating the Header Float Control Lockout
NOTE:
The header
MUST
be attached to the windrower to perform this procedure. The cab display module (CDM) automatically
adjusts its programming for each header.
1009066
CXXX
MXXX
WINDROWER SETUP?
NO/YES
A
B
C
Figure 4.54: CDM Programming Buttons
1.
Turn ignition key to RUN, or start the engine.
2.
Press PROGRAM (A) and SELECT (C) on the cab display
module (CDM) to enter programming mode.
•
WINDROWER SETUP? is displayed on the upper line.
•
NO/YES is displayed on the lower line.
3.
Press right arrow (B) to select YES. Press SELECT (C).
•
SET KNIFE SPEED? is displayed on the upper line.
1009221
CXXX
MXXX
NO/YES
SET CONTROL LOCKS?
B
A
Figure 4.55: Control Locks
4.
Press SELECT (B) until SET CONTROL LOCKS? is displayed on
the upper line.
•
NO/YES is displayed on the lower line.
5.
Press right arrow (A) to select YES. Press SELECT (B).