215015
99
Revision A
4.3.3
Setting the Rotary Disc Overload Speed
This topic applies to rotary disc headers only.
The rotary disc overload speed is the point at which a warning will appear on the cab display module (CDM). When the disc
speed drops below the rotary disc overload speed setting, this indicates the disc drive is overloaded, and a warning is
displayed.
NOTE:
•
The header
MUST
be attached to the windrower to perform this procedure. The cab display module (CDM)
automatically adjusts its programming for each header.
•
The recommended disc overload speed is 75% of disc speed. For more information, refer to the rotary disc header
operator
’
s manual to determine proper overload speed.
1009066
CXXX
MXXX
WINDROWER SETUP?
NO/YES
A
B
C
Figure 4.21: CDM Programming Buttons
1.
Turn ignition key to RUN, or start the engine.
2.
Press PROGRAM (A) and SELECT (C) on the cab display
module (CDM) to enter programming mode.
•
WINDROWER SETUP? is displayed on the upper line.
NO/YES is displayed on the lower line.
3.
Press right arrow (B) to select YES. Press SELECT (C).
•
SET KNIFE SPEED? is displayed.
1009146
CXXX
MXXX
DISC OVERLOAD SPD?
-300 RPM
D
C
B
A
Figure 4.22: Disc Overload Speed
4.
Press SELECT (D) until DISC OVERLOAD SPD? is displayed on
the upper line.
•
The current overload speed is displayed on the
lower line.
NOTE:
Default setting is -300 rpm. Range is -500 to -100 rpm.
5.
Press left (B) or right (C) arrows to set disc overload speed.
Press SELECT (D).
6.
Press PROGRAM (A) to exit programming mode or press
SELECT (D) to proceed to next WINDROWER SETUP action.
