215015
136
Revision A
4.8.4
Forcing a Header ID
The header must be attached to the windrower to troubleshoot certain issues. If damage has occurred to the header wiring
or no header is available, you can force the windrower control module (WCM) to read a header ID. The WCM reverts to
reading NO HEADER each time the engine ignition is cycled.
IMPORTANT:
Forcing a Header ID that is different from the attached header can damage the windrower and header. Doing so can lead to
vibration, belt failures, and other overspeeding related problems.
1009099
CXXX
MXXX
WINDROWER SETUP?
NO/YES
A
B
Figure 4.107: CDM Programming Buttons
1.
Turn ignition key to RUN, or start the engine.
2.
Press PROGRAM (A) and SELECT (B) on cab display module
(CDM) to enter programming mode.
•
WINDROWER SETUP? is displayed on the upper line.
1009288
CXXX
MXXX
DIAGNOSTIC MODE?
NO/YES
A
B
Figure 4.108: Diagnostic Functions
3.
Press SELECT (B) until DIAGNOSTIC MODE? is displayed in
upper line.
•
NO/YES is displayed on the lower line.
4.
Press right arrow (A) to select YES. Press SELECT (B).
