215015
111
Revision A
4.3.15
Setting the Engine Intermediate Speed Control rpm
The engine operating speed can be programmed to enable the windrower to operate at reduced engine rpm (that is, 1900,
2050, or 2200 rpm) without significantly affecting the ground or header speeds. The default setting is 2200 rpm or the last
selected rpm.
NOTE:
The engine
MUST
be running to perform this procedure.
1009066
CXXX
MXXX
WINDROWER SETUP?
NO/YES
A
B
C
Figure 4.47: CDM Programming Buttons
1.
Start the engine.
2.
Press PROGRAM (A) and SELECT (C) on cab display module
(CDM) to enter programming mode.
•
WINDROWER SETUP? is displayed on the upper line.
•
NO/YES is displayed on the lower line.
3.
Press right arrow (B) to select YES. Press SELECT (C).
•
SET KNIFE SPEED? is displayed on the upper line.
CXXX
MXXX
SET ENGINE ISC RPM?
NO/YES
1030043
B
A
Figure 4.48: Engine ISC RPM
4.
Press SELECT (B) until SET ENGINE ISC RPM? is displayed on
the upper line.
•
NO/YES is displayed on the lower line.
5.
Press right arrow (A) to select YES. Press SELECT (B).
•
PRESS HAZARD TO SET is displayed on the upper line.
•
ISC RPM #### is displayed on the lower line.
Table 4.1 ISC Settings
ISC and rpm
Off
8
1
2
3
High Idle (M155)
9
2200
10
2000
1800
NOTE:
The previously selected ISC rpm will be flashing.
8.
Off is always used when the header is not engaged.
9.
Off does not appear on menu selection, but is used when the header is not engaged.
10. Default setting.
