215015
202
Revision A
1000767
A
B
Figure 6.79: Header Leg and Boot
4.
Drive the windrower slowly forward until boots (A) enter
header legs (B). Continue driving slowly forward until the
lift linkages contact the support plates in the header legs
and the header nudges forward.
5.
Ensure the lift linkages are properly engaged in the header
legs and are contacting the support plates.
1008810
A
C
B
D
Figure 6.80: Mechanical Center Link
6.
Stop engine and remove key from ignition.
7.
Loosen nut (A) and rotate barrel (B) to adjust length until
the link is aligned with the header bracket.
8.
Install clevis pin (C) and secure with cotter pin (D).
9.
Adjust length of link to achieve proper header angle by
rotating barrel (B). Tighten nut (A) against barrel (a slight
tap with a hammer is sufficient).
1008946
A
Figure 6.81: Ground Speed Lever
10. Start the engine.
11. Press HEADER UP switch (A) to raise header to maximum
height.
12. If one end of the header does
NOT
fully raise, rephase the
lift cylinders as follows:
a.
Press and hold the HEADER UP switch until both
cylinders stop moving.
b.
Continue to hold the switch for 3
–
4 seconds. Cylinders
are now phased.
NOTE:
It may be necessary to repeat this procedure if there is air in
the system.
