215015
189
Revision A
6.1.3
Attaching an A Series Header
A30D, A30S, and A40D headers can be attached to an M155 Self-Propelled Windrower.
1000777
Figure 6.45: M155 and A40D Auger Header
The M155 Self-Propelled Windrower is factory-equipped to run
an A Series Auger Header.
Windrowers equipped with A Series hydraulics have four
header-drive hoses on the left side.
The attachment procedure varies depending on the type of
center-link installed on the windrower. Refer to the following
instructions based on the type of center-link installed on your
windrower:
•
Attaching an A Series Header: Hydraulic Center-Link with
Optional Self-Alignment, page 189
•
Attaching an A Series Header: Hydraulic Center-Link without
•
Attaching an A Series Header: Mechanical Center-Link, page
Attaching an A Series Header: Hydraulic Center-Link with Optional Self-Alignment
WARNING
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove the key
from the ignition before leaving the operator
’
s seat for any reason.
1.
Shut down the engine, and remove the key from the ignition.
1000778
A
B
C
Figure 6.46: Header Boot
2.
Remove hairpin (A) from clevis pin (B) and remove clevis
pin from header boots (C) on both sides of the header.
