215015
82
Revision A
Table 3.4
Engine Start Troubleshooting (continued)
Problem
Solution
•
Replace clogged filter
•
Ensure fuel shut off valve is in open position
Old fuel in tank
•
Drain tank
•
Refill with fresh fuel
Water, dirt, or air in fuel system
•
Drain, flush, fill, and prime system
Improper type of fuel
•
Drain tank
•
Refill with correct fuel
Crankcase oil too heavy
•
Replace with recommended oil
Low battery output
•
Test the battery
•
Check battery electrolyte level
Poor battery connection
•
Clean and tighten loose connections
Faulty starter
•
Refer to the windrower technical manual
Wiring shorted, circuit breaker open
•
Check continuity of wiring and breaker (manually reset)
Faulty injectors
•
Refer to the windrower technical manual
3.18.11
Priming Hydraulic System
Air must be removed from the system for the hydraulics to perform properly. The following procedure describes the
method for priming the hydraulic system to remove trapped air. Prime the hydraulics after initial installation or if the
hydraulic system requires adjustment.
1005753
A
Figure 3.111: Filler Cap / Dipstick
1.
Remove the hydraulic oil reservoir filler cap / dipstick (A).
2.
Open the engine compartment hood to the highest
position.
