3.ENGINE
3-
66
1. Half plain bearing of connecting rod big end
2. Split surface of the connecting rod
3. Nose of plain bearing in line with connecting
rod groove
Oil the plain bearing surface of the connecting rod
and crank pin before installation.
NOTICE
Lower cap and rod must match together
since there is a cracked surface.
Oil NEW connecting rod screws
NOTICE
Always use NEW connecting rod screws
at final assembly. They are not reusable.
Thread screws in the connecting rods, then tighten
as per fo11owing procedure.
NOTICE
Strictly adhere following instructions:
- Do not apply any thread locker.
- The running direction of the big end bearings and
of the piston pins must not change.
- Always perform each step on both connecting rod
-Failure to strictly follow procedure may cause
connecting rod screws to loosen and lead to Severe
engine damage.
REQUODE TOOLS
Torque wrench
Angle torque wrench
1. Angle torque wrench
NOTICE
Connecting rods are asymmetric.
There must be no gap between the small ends
when they face each other.
1. Connecting rod small ends
Summary of Contents for UTV1000-3
