4. COOLING SYSTEM
4-
9
To remove outer part of rotary seal,
use an expander from puller kit.
Install expander snugly against
outer part and pull rotary seal out.
Remove inner oil seal.
1.
Inner seal
2.
Rotary seal surface
CAUTION: Be careful not to
damage the rotary seal surface in
crankcase.
Inspection
Inspect water pump gear for wear
and damage on the snap mechanism
to the needle pin. Replace if
damaged.
Shaft/Seal installation
For installation, reverse the removal
procedure.
However, pay attention to the
following.
NOTE: For installation use the
torque values. Ensure to use
multipurpose grease oil seal.
CAUTION: Always replace rotary
seal and water pump shaft together.
Also, install a new inner oil seal
(behind rotary seal) at the same
time.
Apply engine oil on the water pump
Summary of Contents for UTV1000-3
