3.ENGINE
3-
64
1. Connecting rod screws
Measure crankpin . Compare to inside diameter of
connecting rod big end.
1. Micrometer
2. Crankpin area for plain bearing
CRANK PIN DIAMETER
ENGINE
NEW
41 .986 mm to42.010 mm
(1 653in to1.6539in)
SERVICE
LIMIT
41. 967mm(1 6522 in)
If the crank pin diameter is out of specification,
replace crankshaft.
To measure the connecting rod big end diameter,
use the OLD connecting rod screws.
Install the OLD plain bearings as they were
mounted initia11y.
Carry out the tightening procedure described in
CRANKSHAFT ASSEMBLY in this subsection.
A.
Connecting rod, big end plain bearing
CONNECTING ROD BIG END RADIAL
ENGINES
SERVICE
LIMIT
42.100mm(1.6575in)
If connecting rod big end diameter is out of
specification, replace plain bearings and recheck.
CONNECTING ROD BIG END RADIAL
ENGINES
SERVICE
LIMIT
0.09mm(.0035in)
If connecting rod big end radial clearance is out of
specification, replace plain bearings and recheck.
Crankshaft Radial Play MAG/PTO Side
Measure crankshaft on MAG/PTO side . Compare
to inside diameter of MAG/PTO plain bearing
(refer to CRANKCASE).
1. Micrometer
2. Crankshaft area for MAG plain bearing
Summary of Contents for UTV1000-3
