Liangzi Power UTV1000-3, Maintenance Manual, Page: 180 / 184

11. TROUBLESHOOTING
11- 10
2. Check drive belt identification number.

Excessive belt speed. Using unspecified type of belt. Replace belt with
proper type of belt.
3. Check if pulley sheaves are clean.

Oil on pulley surfaces. Clean pulley surfaces with fine emery cloth and
wipe clean using pulley flange cleaner and a cloth.

Drive/driven pulley sheaves are damaged through stones inside CVT area.
Clean pulley surfaces with fine emery cloth, wipe clean with a cloth or replace
drive/driven pulley sheaves and belt.
Symptom: BACK BETWEEN COGS
1. Check drive belt condition.

Considerable use, belt wearing out. Replace.

Brittle belt condition through aging. Replace belt.
ENGINE GENERAL
Symptom: ENGINE CRANKS BUT FAIL TO START
1. Check if spark plug connectors fit on spark plugs (refer to IGNITION SYSTEM).
2. Check spark plugs.

Define spark plugs (no spark) or wrong spark plug gap. Readjust gap and
clean spark plugs or replace.
3. Check for fuel on spark plugs.

Flooded engine (spark plugs wet when removed). Activate engine drowned
mode and crank engine with rags over the spark plug holes.
4. Check battery voltage.

Battery is discharged and starter works not properly. Charge battery.
5. Check fuel level in fuel tank and fuel pressure. Ensure fuel pump was not disabled.
-- Low or no fuel pressure. Replace defective part(s).
6. Check fuel injectors.

Plugged or faulty injector(s).Replace defective part(s).
7. Check idle bypass valve.

Stuck or defective..
8. Check encoder wheel.

Bent tooth. Refer to MAGNETO SYSTEM.
9. Check engine compression.

Insufficient engine compression. Replace defective part(s).
10. Check fault codes in DELPHI. system.

Check if electrical actuator(s) is/are defective. Replace defective part(s)
(refer to COMPONENT INSPECTION AND ADJUSTMENT).
Symptom: ENGINE DOES NOT START
1. Electrical problem.

Determine if the electrical system works correctly (fuse(s), battery, wiring
harness, etc.). refer to IGNITION SYSTEM.